What about stone machinery + PLC?

Stone machinery is widely used in the industry. With the rapid development of the stone industry, the requirements for deep processing of stone are increasing. Stone machinery is also following the footsteps of the times and gradually becoming intelligent. At present, most of the domestic stone cutting machines adopt the traditional relay-contactor control mode, the control method is relatively backward, the cutting precision is poor, and the personnel need to carry out on-site control during cutting, which poses a threat to personal health. In response to this situation, we have conceived a stone machinery + PLC method to solve this problem. I will explain it to you now.

The method is to input the required cutting parameter of the stone into the human interface (HMI) to initialize the PLC, and use the rotary encoder to replace the traditional travel switch or limit switch for cutting length positioning. The rotation frequency of the motor in each direction is measured by a rotary encoder and converted into a high-speed counting pulse and sent to the PLC for counting operation to obtain an accurate displacement amount of the knife saw or the trolley traveling, and compared with the set initial value, when reaching When setting the value, the PLC resets the corresponding direction motor coil to stop it. The operation is simple and safe.

http://www.yf2so.com/

China Yunfu Old Stone Machinery

+8613580655319   Mr. Ding

QQ  454604388

mail  454604388@qq.com